|
|
Submitted By: Date: April 20, 2006, 04:00:17 AM Views: 2685 | ||
Summary: all the image links are broken | ||
{mosimage} {mosimage} Ingredients One Vyper I cut away the front part of the Vyper, and glued pieces of paperclips in there : this is the front air-intake. From the pointy bits I had leftover from this cutting process I made the skids later on. I cut off the Vypers’ wings in one piece, just behind the cockpit. I turned these upside down to glue them back on (with loads of putty to create a decent bonding-surface). So now the wings are pointing upwards. Then I took the rear of the Speeder I had lying around from a previous conversion and started trying to fit that to the rear of the Vyper. Now came the tricky cutting part where I wanted parts of the Speeder covering over the wings of the Vyper etc. Kind of like a slot where the wings slide in. Now I still had quite a gap between the Vypers' cockpit and the Speeders' rear end (where the shooty platform of tghe Vyper was supposed to be). Now there were still 2 huge gaps on the landspeeder (where it's front is supposed to be) so I did the same as for the front air-intake : paperclips Now it was all a question of adding some plasticard plates here and there representing repair jobs and to create some bullet impacts. |
||
Rating: This article has not been rated yet. |
||
|